Subject:DR600 Mod Hi, I just got the info on how to modify the Alinco DR-600 I have activated these mods
and they seem to work fine Here they are:Mod 1 - Activate 108 - 142 MHz and 810 - 998 MHz Receive
--------------------------- Remove head unit from radio and open it up Inside
you will see a red and blue wire Cut the red wire Open the main unit and attach a wire to CN-205 This will
be your antenna for 810-998 MHz Close everything up Reset the CPU by holding down the FUNC key while you
turn the radio on To use:The VHF key toggles between 108-142 and 2m This toggle only works in VFO mode.
The UHF key toggles between 810-998 and 70cm This toggle only works in VFO mode Mod 2 - Extened tx/rx on 2m
and 70cm ------- Remove head unit from radio and open it (2 screws on back)
Inside you will see a red and a blue wire Cut the blue wire Put everything back together Reset the CPU by
holding down the FUNC key while you turn the radio on You can now transmit and receive on the following
freqs:130-174MHz and 400-517MHz Be carefull!!!!! You can now transmit outside of the HAM bands Don't do
this! If you do you WILL get caught and the FCC loves those $10,000 fines NOTE:I take no responsibility for
these modifications If you blow up your radio it is not my fault If you have any questions about these mods
call Alinco Chris Levin levin@cosmic.physics.utah.edu
Source QRZ: The Windows Ham Radio CDROM |
