Subject:BAND EXPANSION MODIFICATION FOR ICOM MICRO2 ===== 1. Remove battery. 2. Remove 4 screws securing battery. Slide from front panel. 3. Remove small black screw below PTT switch. 4. Carefully separate the front speaker from the body by pulling front and rear down toward battery. Flip it over. 5. Next remove steel chassis assembly by gently prying up the sides, lift up, fold it down. 6. Solder in new diode next to Q131 and Diode D113. Looking at Diode Matrix with top of radio to the top, add diode to the empty pad to the left of diode D119. There are 3 points of connection on the diode pad. Two on the left and one centered vertically on the right. The diode should be installed between the lower left and the right centered connection. (Arrow on diode points to right centered connection.) 7. Reset CPU by following instruction manual page 23. ---------------------------------- *** Be careful not to transmit out-of-band, or accidentally operate on any non-amateur, unless you are authorized to do so. DO NOT JEOPARDIZE YOUR LICENSE! [EOF]  Amsterdam View Our Stats   CLICK FOR A FREE DOMAIN NAMES HTTP://WWW.YOURNAME.TK FOR YOUR OWN WEBSITE IF YOU CLICK HERE AND YOU CAN VOTE FOR OUR FREE WEBSITES IN THE TOP 100 LIST  WANT A TOP RANKING ? USE THE ULTIMATE SOFTWARE SUITE FOR WEB SITE PROMOTION  FreeWebSubmissions Submit Your Site To The Web's Top 50 Search Engines For Free THE ALEXA BANNER, THIS BANNER GIVES THE DALLY STATISTICS OF THIS FREE WEB SITE The World of Free Packet Radio Software Amsterdam The World Of Free Packet Radio Software Amsterdam The Netherlands |